
From harbor-view patios to hillside backyards, we restore teak furniture and decking on-site across Redondo Beach.
Trusted across Redondo Beach by
There is no charge and no obligation. The point of the visit is a realistic scope and price, and often a recommendation to do less than you expected.
A few pictures in daylight usually tell us the tier of work and a rough range before anyone drives out.
Around thirty minutes at your Redondo Beach property. We test the surface, check joints and count pieces.
Piece by piece, with the finish specified and the number of coats stated, not implied.
Booked around your week, your events and, for HOAs and hotels across Los Angeles County, your operating calendar.
Full masking, dust containment and a tidy site at the end of each day, whether or not anyone is home.
A care sheet with your specific product, interval and the two or three habits that matter most.
Redondo Beach's identity is tied to its harbor and marina, and that means a lot of local teak furniture and even boat teak trim sits within a stone's throw of open water. Between King Harbor's docks, the Esplanade's oceanfront properties, and the Riviera's hillside homes, we see teak in nearly every stage of wear across the city.
Marina-adjacent furniture faces a different challenge than what we see in inland communities: constant low-grade salt mist plus boat traffic exhaust residue that settles on outdoor surfaces. This combination can leave teak looking dirtier and darker than simple sun fading alone would cause, and it needs a different cleaning approach before refinishing.
We also work with owners of teak boat accessories — cockpit tables, swim step treads, companionway trim — brought ashore for restoration, alongside the patio furniture and dining sets more typical of a harbor-view condo or Riviera hillside home.
Homes up in the Hollywood Riviera and North Redondo tend to be set back from direct salt spray, so their teak ages more slowly, often just needing a cleaning and re-oil rather than a full strip-and-sand. Down near the harbor and the Esplanade, we more often start from bare wood.
Whatever the setting, our process happens at your property — dock, patio, or backyard — so there's no need to transport furniture or boat teak off-site.
Furniture within a block of King Harbor typically needs a full strip-and-refinish sooner than pieces set back in the Riviera or North Redondo.
Coastal light is not just direct. Water, pale stone and glass rails all reflect UV back upwards, so the undersides of Redondo Beach armrests and table aprons weather far more than they would on an inland patio.
The practical result is that shading a piece helps less here than people expect. An umbrella cuts the direct load but does little about the reflected component, which is why we assess the whole setting rather than just the orientation of a piece.
It also explains uneven sets: a chair pulled slightly further towards a glass balustrade greys measurably faster than the one beside it, and colour-matching across the set during finishing is what makes them read as a group again.
Furniture is most of the work but rarely all of it. These are the fixed and functional pieces we are asked to bring in line with a restored set.
Restored in place with surrounding stone, render and planting fully masked before any sanding starts.
Vertical exterior joinery where the finish fails first at the top rail and the bottom edge.
Constant wetting demands a different specification from anything on a dry terrace.
High, awkward and rarely maintained, which is why they are usually the greyest wood on a property.
Cockpit tables, rails, swim platforms and trim finished to marine standards in the slip.
Teak, ipe and mahogany decks across Redondo Beach, cleaned, flattened and re-oiled to match the furniture on them.

Hand-finished
Every grain inspected, sanded and sealed by a master craftsman.
We record the condition of each piece before work starts, so the before-and-after is documented rather than described.
Stone, glass, pool coping and planting are covered. Teak dust is fine and travels, so containment is set up before any abrasive runs.
Old varnish and film finishes come off chemically. Sanding through a failed film only drives it deeper into the grain.
Coarse work flattens eroded early-wood, then finer passes close the grain without burnishing it shut.
Oil goes on until the wood stops taking it, then the excess is wiped off within the working window.
We leave the pieces to cure, then come back to buff any raised grain and reset your furniture layout.
Restored teak can be finished anywhere between a pale, matt honey and a deep, almost amber brown, and the difference is mostly product choice and coat count rather than stain.
We sample on your own wood before committing the set, because the same oil reads differently on old, dense teak than on newer plantation stock, and photographs of other projects are a poor guide.
Darker is not automatically better outdoors. Deep tones absorb more heat, which shortens the interval on pieces in full sun, and that trade-off is worth making deliberately.
Recent work, photographed on handover day in natural light. No staging, no filters, no replacement pieces.
Newport Coast, CA
Newport Beach, CA
On-site teak restoration, refinishing and outdoor furniture restoration throughout Redondo Beach and every neighboring South Bay community.
Teak restoration is available across the neighbouring coastline and inland communities near Redondo Beach.
Near the ocean, three separate forces act on outdoor wood at once. Understanding which one is doing the damage changes how you maintain it.
Read guideFreshly restored teak needs very little. What it needs, it needs consistently.
Read guideSun does not just fade colour. It breaks down the material that holds wood fibres together, and it degrades the finish protecting them.
Read guideSend a few photos or book a visit. Either way you get a fixed price and an honest scope.
Tell us what you have, how it is used and roughly how long since it was last finished. That is enough for a realistic range.